Publicidad
Idiomas disponibles
Idiomas disponibles
CARE AND MAINTENANCE
12. Replacing the Scraper Bar
WARNING
Make sure to turn off the snow blower by releasing
the bail switch and remove the battery pack(s)
before performing any maintenance task on your
snow blower.
a. The scraper bar (S) is located at the bottom of
the snow blower beneath the auger (Fig. 12a).
b. Turn the snow blower on its side (Fig. 12b).
c. To reduce the risk of injury, wear gloves. Use
a 5/16" (8mm) socket wrench (not included) to
remove the 5 nuts (Fig. 12c). Detach the worn
scraper bar from the snow blower.
d. Attach the new scraper bar to the snow blower
with the shiny surface facing the inside of the
deck. Align the mounting holes in the scraper
bar with the holes in the deck. Insert the 5 bolts
into the mounting holes from the inside, shiny
surface of the scraper bar (Fig. 12c).
12a
12b
Nut
Scraper Bar
12c
20
S
Bolt
Nut
Washer
Shiny
surface
Publicidad
