Publicidad
Idiomas disponibles
Idiomas disponibles
[STEP 2] Setting the IP address
Refer to "Static IP Setting" on page 28 or "Dynamic IP Setting" on page 32.
[STEP 3] Connecting a local PC in the IP router to the camera
1
Run the IP Installer on your local PC and
search for the camera.
2
If found, double-click the camera to
start the Internet browser and try to
connect to the camera. Alternately,
launch the Internet browser manually
and enter the IP address of the camera
found in the address bar to connect to it.
ex) http://192.168.1.2
[STEP 4] Connecting to the camera from an IP router external PC
1
An IP router external PC can't use the IP Installer to search for an IP router internal
camera. This is because the IP Installer does not work in a network where the gateway is
different.
2
In this case, you can use the DDNS URL of the camera or the Internet IP address of the
IP router to connect to the IP router internal camera.
3
However, you must set the port-forwarding for the IP router before you can connect
to the IP router internal camera from a remote PC. For more information on the
port-forwarding, refer to Use IP Router: Port Forwarding Setting (Port Mapping).
4
When the port forwarding is done, run the Internet browser on the IP router External
PC and enter the DDNS URL address or, the Internet IP address of the IP router in the
address bar for connecting to the camera.
ex) http://mfffe42.websamsung.net
For the DDNS URL address, refer to "Checking the DDNS address" on page 35.
A remote PC in an external Internet out of the LAN network may not be able to connect to the
camera installed in the intranet if the port-forwarding is not properly set or a firewall is set.
In this case, to resolve the problem, contact your network administrator.
Network Connection & Setup
_23
Publicidad
