Publicidad
Idiomas disponibles
Idiomas disponibles
<E-mail(SMTP) Transfer> : You can transfer an alarm image through Email. This function supports
- <SMTP Server Address>: Enter the IP address of an SMTP server to be used to send an Email.
- <User ID>: Enter a user account ID to connect to connect the SMTP server.
- <Password>: Enter a user account password to the SMTP server.
- <E-mail Sender>: Enter the address of the Email sender. If the sender address is incorrect, the Email
- <E-mail Receiver>: Enter the address of the Email recipient.
- <Title>: Enter the title of the Email.
- <Message>: Enter the contents of the Email. An alarm image is attached to the Email as an attached
file.
To test Email transmission
Click the [Test] button.
Connect to the configured SMTP server
and conduct image transmission test
automatically.
When the SMTP server connection and
transmission tests are complete,
the <Verified> message will be displayed.
If the test fails, an error message appears.
In this case, check the SMTP server status
and the configured settings once again.
To setup the record
1
Click <EVENT> <RECORD SETUP>.
The RECORD SETUP window appears.
2
To complete the setting,
click the [Apply] button.
The settings are saved.
<SD Card>: Enables you to verify data saved on the SDHC memory card and format the
memory card itself. It is possible to set to automatically delete movie clips
recorded before a certain period of time (e.g. 1 week, 1 month, or 1 year).
<Options>: Determine whether or not you wish to receive Email notification of insufficient
capacity warnings.
62_
Setting Up
SMTP Email server only. When the initial SMTP server setting and
connection are not verified, the <Not verified> message appears.
Example) smtp.hotmail.com
from the sender may be classified into SPAM mail by the SMTP server and may
not be sent.
Publicidad
