Replacing The Power Cable; Cleaning, Maintenance And Ordering Of Spare Parts; Ordering Replacement Parts; Disposal And Recycling - EINHELL RT-HA 2000 E Manual De Instrucciones Original

Anleitung_RT_HA_2000_E_SPK7__ 01.08.12 09:35 Seite 12
GB
Important: Intense exposure to heat raises the
risk of fire and explosion!
Make sure the workplace is well-aired. The
remaining gases and vapours could be damaging
to health/or poisonous.
7.3 Selecting the right nozzle
Heat nozzle (4) protects materials (e.g. glass
n
panes) from the hot air by redirection. For
removing paint.
The wide nozzle (5) provides uniform air
n
distribution on small surfaces.
The reducer nozzle (6) provides a targeted jet of
n
heat for corners and for soldering work.
The reflector nozzle (7) is designed for soldering
n
and shaping tubes, for defrosting water pipes
and for shrinking insulating hoses.

8. Replacing the power cable

If the power cable for this appliance is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
9. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
9.1 Cleaning
Keep all safety devices, air vents and the motor
n
housing free of dirt and dust as far as possible.
Wipe the appliance with a clean cloth or blast it
with compressed air at low pressure.
We recommend cleaning the appliance
n
immediately after every use.
Clean the appliance regularly with a damp cloth
n
and some soft soap. Do not use cleaning agents
or solvents; these may be aggressive to the
plastic parts in the appliance. Ensure that no
water can get into the interior of the appliance.
9.2 Maintenance
There are no parts inside the appliance which require
additional maintenance.
12

9.3 Ordering replacement parts:

Please provide the following information on all orders
for spare parts;
Model/type of the appliance
n
Article number of the appliance
n
ID number of the appliance
n
Spare part number of the required spare part
n
For our latest prices and information please go to
www.isc-gmbh.info

10. Disposal and recycling

The appliance is supplied in packaging to prevent it
from being damaged in transit. This packaging is raw
material and can therefore be reused or can be
returned to the raw material system. The appliance
and its accessories are made of various types of
material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.