Publicidad
9
CARACTERÍSTICAS TECNICAS
MIMO88
DSP
Converters
Analogue
Analogue Input headroom
Input sensitivity @ 0dBV out
Frequency response (-3dB)
THD+Noise @ 1kHz, 0dBV input (line)
THD+Noise @ 1kHz, -40dBV input (mic.)
Output Noise floor FFT (20Hz - 20kHz)
Interchannel crosstalk (20Hz - 20kHz)
Channel Leakage (20Hz - 20kHz)
Processing
DSP
2 x 32/64bit
Sampling Rate
48kHz
Latency IN to OUT
<2.9ms (+1ms for 16x16)
Resolution
Dynamic Range
8+8 Input/Output
Terminal block (Symmetrical)
2 monitor output
Terminal block (Symmetrical)
Headphones related
Jack ¼
+27dBV = +30dBu
Max. output level
+18dBV = +21dBu
From -50dBV to +10dBV in 0.5dB step
Input Impedance
Balanced, >4kΩ
Phantom power
+42VDC, 5mA max. software switched
Headphones
>200mW/200Ω
5Hz to 24kHz
Flatness
better than ±0.1dB
<0.004%
<0.008%
better than 115dB
better than 90dB (100dB typ.)
better than 100dB (115dB typ.)
CMRR 20Hz- 20kHz
65dB typ.
Input Level (x8)
Range: from Off to 0 dB
Mute: Yes
Signal Polarity reverse: Yes
Metering: VU+clip pre & post fader
Output Level (x8)
Range: from Off to 0 dB
Mute: Yes
Solo: Yes
Signal Polarity reverse: Yes
Metering: VU+clip pre & post fader
Output Gain
Range: from 0 to +6 dB
Input Delay (x8)
from 0 to 1000 ms
Units: sec/ms/m/cm.
Output Delay (x8)
from 0 to 1000 ms
Units: sec/ms/m/cm.
16
24bit AKM
AD:110dB, DA: 115dB
Publicidad
