Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
1. Customer takes a number from the dispenser and
waits until the number appears on the display.
2. Press the (+) push button once to display the next
number.
3. Press and hold the (+) push button to advance the
numbers by tens.
4. Use the (–) push button to go back one number at a
time.
NUMBER DISPENSER
Number dispenser can be mounted to either the wall or
stand.
WALL MOUNTING
1. Mark mounting holes on wall using dispenser
mounting bracket as a template. (See Figure 1)
2. Drill holes using 3/16" to
5/16" drill bit.
3. Use wall anchors if
attaching to surfaces
other than solid wood.
4. Position dispenser
mounting bracket
(longer holder at the
top) over holes in wall
and fasten with two
slotted screws. (See
Figure 2)
5. Snap dispenser into bracket. (See Figure 3)
Sign
Figure 2
STAND MOUNTING
1. Position mounting stand in the desired location on
countertop.
NOTE: For clean, smooth surfaces, remove
backing from adhesive strips on the base of
the stand and secure to surface.
PAGE 3 OF 18
OPERATION AND USE OF DISPENSER
Figure 1
Figure 3
NOTE: For permanent mounting, use the base
of stand as a template, mark and drill four
holes and secure base of stand to surface with
four screws (not included).
2. Align holes in dispenser mounting bracket (longer
holder on top) with holes in post. Push two large
slotted bolts through bracket and sign and secure
with nuts. (See Figure 4)
3. Snap dispenser into bracket. (See Figure 3)
LOADING DISPENSER
1. Pull down locking bar to open dispenser.
2. Drop in number roll (not included) so the numbers
roll out from the bottom. (See Figure 5)
Number Roll
(not included)
3. Pull end of roll through end of dispenser. Close
dispenser and snap locking bar back into place.
Bottom View
Adhesive Strips
Figure 4
Locking Bar
Figure 5
0421 IH-4017
Publicidad
