Stihl iMOW 5.0 Manual De Instrucciones página 72

English
the main mowing area (A) through the corri‐
dor (1) to the other mowing area (B). Starting
points can be set using the MYiMOW
► If it is not possible to maintain the minimum
width between the perimeter wires: Block off
the other mowing area (B) from the main mow‐
ing area (A) and install an adjacent area.
8.13
R R
L L
L
R
L R
► Route the perimeter wire (4) as illustrated and
make sure that the correct position of the wire
loops (5) has been maintained:
– The wire loops (5) must be routed to the
left = (L) in the direction of travel to the
docking station.
– The section where the perimeter wires (4)
lie close and in parallel to each other are on
the right = (R) in the direction of travel to the
docking station.
a
d
4
► Route the perimeter wire (4) as illustrated and
make sure that the following dimensions have
been maintained:
– Width between the perimeter wires in the
corridor: a = 55 cm
– Minimum distance to side obstacles:
b = 15 cm
72
®
app.
4
5
b
d
c
b
8 Installing the Perimeter Wire
– Minimum corridor length: c = 74 cm
®
(2x iMOW Ruler)
– Distance of perimeter wires of the wire loop:
d = 37 cm (length: 1x iMOW
e
90°
► When installing the guide wire (2), make sure
that the following dimensions and distances
are maintained:
– The guide wire (2) is installed in the center
of the corridor.
– Route guide wire (2) before the corridor for
a length of at least e = 37 cm (length:
®
1x iMOW Ruler) in a straight line and at a
right angle (90°) to the corridor.
– Route guide wire (2) after the corridor for a
length of at least f = 2 m in a straight line
and at a right angle (90°) away from the cor‐
ridor.
8.12 Inclines/slopes
The robot mower can navigate and mow inclines
up to 40%.
► If there is an incline/slope up to 27% within the
mowing area: Install perimeter wire normally.
®
Ruler)
f
90°
0458-011-9801-A