Bit Installation - Kreg Precision Router Lift PRS5000 Manual Del Propietário

Insert Rings
Unlock

Bit Installation

General Routing
Fine Adjustment
Indexing Ring
STEP 1: To install an insert ring, place it into the lift-plate opening and turn it by
hand until it drops flush with the plate surface. Turn the ring counterclockwise with
the ring wrench.
STEP 2: To remove an insert ring, turn it clockwise with the ring wrench.
Lock
Lift the ring out of the opening.
opening to the diameter of the router bit in use. The ring with the rabbeted opening accepts
universal-style guide bushings, allowing you to use your router table for pattern routing.
of the router bit in use.
STEP 1: Remove the insert ring and raise the carriage to the full-up position.
Use the wrenches supplied with your router to install the bit.
STEP 2: Lower the carriage and replace the insert ring. Raise or lower the carriage to
position the bit and turn the LOCK bushing clockwise.
1: Use the insert-plate reducing ring with the smallest opening that allows the bit to
pass through it.
2: Position the fence faces as close as possible to the bit. Turn the bit by hand to check
for interference. Firmly tighten the fence-face T-knobs before routing.
3: Position the bit guard over the router bit and as close to the workpiece
surface as possible.
4: Feed the workpiece against (not with) the bit rotation.
STEP 1: With the bit at the desired height and the carriage locked, use your fingers
to turn the micro-adjustment dial until the zero mark aligns with the indexing line on the
router-lift plate. Test the setup on a scrap workpiece and shut off the router.
STEP 2: Unlock the carriage and raise or lower the carriage as needed. One full turn
of the crank equals
Indexing Line
Using the Lift
The lift includes three insert rings for flexibility in matching the size of the
ATTENTION
WARNING Always use the insert ring with the opening size closest to the diameter
Always tighten the carriage lock before routing.
WARNING
" difference in bit height.
⁄
1
16