Descargar Imprimir esta página

Bedfont NObreath Guia De Inicio Rapido página 3

Ocultar thumbs Ver también para NObreath:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 6
EN
NObreath
FeNO testing without limits.
Features
FeNO testing
without limits*
Portable
PC Software
Low
maintenance
* Subject to correct use, maintenance and service. Tested up to 29,000 tests.
PLEASE CHARGE THE DEVICE IMMEDIATELY!
The NObreath® should be charged for a minimum of 24 hours before first use.
®
Easy to use
Adult and child
FeNO testing
Low-cost
Bluetooth
Technology
PAGE 4
Taking a Breath Test
1. Press and hold the on/off button once to switch the device on and wait up to 60 seconds for
the device to stabilise.
2. Attach a new mouthpiece to the Device and select either the adult
NOTE: To cancel the breath test, press the
3. As prompted onscreen by
or
, inhale until prompted to exhale.
NOTE: Ensure the patient inhales through the mouth before exhaling through the
mouthpiece.
4. When the exhale icons appear,
or
mouthpiece. Make sure you are not covering the vent holes.
NOTE: The exhalation time is approximately 12 seconds for an adult and 10 for a child.
5. The onscreen flow meter will guide you on the exhalation rate: continue blowing until the
green tick
appears onscreen to signify a successful test.
NOTE: If you blow outside of the exhalation guidelines, the test will beep, before signifying a
fail, and a red cross
will appear. Touch
6. Following the tick, a result will appear on the screen, in ppb.
7. You may save this result by pressing
. Alternatively, you can return to the home screen by
pressing
.
8. If you choose to save your results you will be shown a list of patient profiles. Select a
previously set profile to add your result to, or select an empty profile to set a new one. Set
the profile by typing in a name or reference, and press
9. Remove and dispose of the mouthpiece in accordance with local waste and disposal
guidance.
10. If no further tests are required, press and hold the on/off button once to turn the
off and store on NObreath
NObreath
®
®
NOTE: A PIN is required to save the reading to a patient profile, the default pin is 0000.
It is highly recommended that you change the PIN to a 4 digit number that you will remember.
If you have not entered your PIN in the last 30 minutes, you will be asked to enter it before you
can access the patient profiles. If your PIN is entered incorrectly, you will be notified and the
screen will refresh for you to re-enter your PIN. If you have forgotten your PIN, please contact
Bedfont® or your local distributor to reset it.
For a full copy of the manual please contact your local distributor.
or child
breath test.
icon.
, keep the device upright and blow gently into the
to retry the test or
to view the result.
.
Dock to charge unit.
PAGE 5
EN

Publicidad

loading