Publicidad
4-6
cC
8 Do not place the outboard motor on its
side before the cooling water has
drained from it completely, otherwise
water may enter the cylinder through
the exhaust port and cause engine
trouble.
8 Store the outboard motor in a dry, well-
ventilated place, not in direct sunlight.
EMU15080
1) Wash the motor body using fresh water.
(Refer to "MOTOR EXTERIOR" for
details.)
2) Remove the fuel-line connection(s)
from the motor or shut off the fuel valve,
if equipped.
3) Run the engine at idling speed while
supplying fresh water to flush the cool-
ing-water passages. Continue until the
fuel system becomes empty and the
engine stops. (Refer to "FLUSHING
COOLING SYSTEM" for details.)
4) For electric start models, remove the
battery. (Refer to "DISCONNECTING
THE BATTERY" for details.)
5) Drain the cooling water completely out
of the motor.
Clean the body thoroughly.
6) Remove the spark plug(s).
7) Pour a teaspoonful of clean engine oil
into the cylinder(s).
8) Crank several times manually.
9) Replace the spark plug(s).
EMU03360
Fuel Tank
1) Drain the fuel from the tank for a long
period of storage.
2) Store the fuel tank in a dry, well-venti-
lated place, not in direct sunlight.
E
Publicidad
