RedMax CZT60TX Manual De Usuario página 24

Grease nipple
A B
A C
Refer to Lubrication
Lubricate the grease nipple on
A
the pivot axle with a grease gun.
Lubricate the grease nipple on
B
the wheel axle with a grease gun.
Lubricate the grease nipples on
C
each spindle with a grease gun.
Lubricate the grease nipple on
D
the cutting deck idler arm.
Always use good quality grease. Always use
recommended oil, refer to
28 .
To lubricate the front wheels
Note:
Use a grease gun when you lubricate the
front wheels.
• Lubricate each set of front wheel mounts (A) and
bearings (B) 3-4 strokes.
A
Tightening torques
Engine crankshaft bolt
Mandrel pulley nuts
Idler pulley nuts
24
A A
A B
A C
A C
D D
Technical data on page
B
To lubricate the cutting deck
spindles
1. Remove the footrest plate (A).
2. Lubricate the 3 cutting deck spindles (B) 2-3
strokes.
Note:
Use a grease gun with a rubber hose
when you lubricate the cutting deck spindles.
3. Lubricate the idler arm (C) 2-3 strokes.
50 ft-lb / 68 Nm
17 ft-lb / 23 Nm
30 ft-lb / 40.6 Nm
A
C
B
2062 - 001 - 08.02.2023