Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
There is vibration in the prod-
uct.
The engine becomes too hot.
The battery does not charge.
The product moves slowly, with
irregular speed or not at all.
The drive of the blades do not
engage.
The transaxle leaks oil.
The cutting result is unsatisfac-
tory.
26
Cause
The blades are loose. Refer to
One or more of the blades are not balanced. Refer to
blades on page 21 .
The engine is loose.
The air filter or the cooling fins are clogged.
There is overload in the engine.
The airflow around the engine is not sufficient.
The engine speed regulator is damaged.
The oil level is too low.
There is dirt in the fuel line.
The spark plug is defective.
The connection at the cable connectors on the battery terminals is bad.
To clean the battery on page 18 .
Refer to
The charging lead is disconnected.
The charging system is defective.
The parking brake is engaged.
The hydraulic release lever is engaged.
The drive belt on the transmission is loose or damaged.
There is air in the hydraulic system.
The drive belt on the mower deck is loose.
The electromagnetic coupling contact is loose.
A fuse is blown. Refer to
The seals, housing or gaskets are damaged.
There is air in the hydraulic system.
The tire pressure is different on the right and left sides. Refer to
pressure on page 19 .
The blades are damaged.
The suspension of the cutting deck is not level.
The blades are blunt. Refer to
The product is operated at too high forward or rearward speed. Refer to
get a good cutting result on page 15 .
The grass is long or wet. Refer to
There is grass blockage in the cutting deck. Refer to
on page 18 .
To examine the blades on page 21 .
Fuses on page 5 .
To examine the blades on page 21 .
To get a good cutting result on page 15 .
To examine the
Tire
To
To clean the product
2062 - 001 - 08.02.2023
Publicidad
