Publicidad
Idiomas disponibles
Idiomas disponibles
TECHNICAL DATA
CHARGE INPUT
Input
Output voltage
POWER OUTPUT
Total output voltage
Battery type
Battery capacity
Charging time for each
battery pack (approx.)
Up to four batteries
can be charged at the
same time
2.0 Ah
4.0 Ah
5.0 Ah
Protection class
Unit Weight (bare)
Each charging port is independent. The charging time for
four battery packs of the same capacity is equal to the
time for a single battery pack.
For the technical data of the types, the number of cells and
the rated capacity of the batteries that can be charged,
please refer the nameplate of the battery pack supplied
by Worx.
CHARGING PROCEDURE
NOTE: Before using the tool, read the instruction
book carefully.
CHARGING-IN MODE
WARNING:
The charger and battery pack are specifically
designed to work together so do not attempt to use any
other devices to charge. Never insert or allow metallic
objects into your charger or battery pack connections
because an electrical failure and hazard will occur.
HOW TO CHARGE YOUR BATTERY PACK (See Fig. A)
NOTE: You can charge 1, 2, 3, or 4 total batteries at one
time.
80V Basecamp-Battery Charger
& 80V Power Source
WA3974
220 V~240 V
50 Hz, 80 W
20 V
1 A
(each battery slot)
80 V
MAX
Powershare
TM
Li-Ion batteries
2.0 Ah/ 4.0 Ah/ 5.0 Ah
2-2.5 hrs
4-5 hrs
5-6 hrs
/II
2.6 kg
NOTE: Your battery pack is UNCHARGED and you must
charge once before use.
1. Plug the battery charger into the proper AC voltage
source.
2. Open the cover, and slide the battery packs into the
charger. Ensure that each battery pack is firmly seated
and does not disengage.
3. The GREEN LIGHTS will blink continuously indicating
that the charging process has started.
4. After charging several hours (depending on the
capacity of each battery pack), three lights will stay
green without flashing, which means the battery is full,
and charging is completed.
5. To remove the battery pack from the power station,
push the battery pack release button and firmly pull
the battery pack out of the charger.
WARNING: When battery charge runs out after
continuous use or exposure to direct sunlight
or heat, allow time for the battery to cool down
before re-charging to achieve the full charge.
POWER INDICATOR
Press the battery indicator button, the light will be on to
indicate the lower common denominator, after 3s, status of
each battery pack will be shown on.
CHARGING INDICATOR
This charger is designed to detect some problems that can
arise with battery packs. Indicator lights indicate problems
(see reference table). If this occurs, insert a new battery
pack to determine if the charger is OK. If the new battery
charges correctly, then the original pack is defective and
should be returned to a service center or recycling service
center. If the new battery pack displays the same problem
as the original Battery Pack, contact Customer Service.
Light
ON/ Flash
One Red on
Two LED-lights
off
----------
One Red flash
Two LED-lights
off
Three Green on
Status
Defective Battery
Battery Temperature
Protection
The temperature of
battery pack is less than
0
0
32
F (0
C) or more than
113
0
F (45
0
C).
Fully Charged
EN
7
Publicidad
