Publicidad
Retaining
Pin
Square
Drive
Socket Installation
CAUTION
Always make sure that the tool is turned
off and unplugged before performing any work on it.
• Select the right socket for the job.
• Align the orifice for the socket retaining pin with the
retaining pin in the square drive.
• Press the socket into the square drive until is set into
position. Tap it lightly if necessary
• To remove the socket, press the retaining pin through
the orifice and pull the socket until removing it from the
square drive.
• Always use impact socket for this tool. Do not use
sockets for hand tools. Consult the
Catalog to learn about our accessory range.
• Use 1/2" sockets for square drives.
• Using adaptors for sockets with other measures is not
recommended. Use them only when strictly necessary.
• If a socket has not been secured and
WARNING
adjusted as indicated it can shoot out and injure the
operator.
6
ENGLISH
Gear
Case
Switch
Preparation
Parts
Motor
Housing
Handle
Power cord
protector
Power
Cord
Impact
Retaining
Socket
Pin Orifice
Retaining
Retaining
Pin Orifice
Pin
Nut or Lug Inlet
Square Drive Inlet
Publicidad
