Anova CL500 Manual De Usuario página 93

4.4.1. step by step instructions
Cut with your right hand holding onto the handle and push the cradle towards the saw (Fig. 7).
If necessary, you can help yourself with the thigh.
By pushing against the cradle, the saw sleeve will rise to allow the cut, and after cutting, it will
return to its initial position, thanks to the tension of the spring.
5. PROBLEM SOLVING
Problem Causes
1. There is no electrical current to the
The engine equipment.
does not work 2. Thermal sensor has interrupted
power supply.
The engine
does not slow 1. The mechanical brake is worn.
down
Engine shuts 1. The thermal sensor is faulty.
down in the 2. Motor circuit breaker shuts it down
middle of work on overload.
1. The cable is too long or its section is
Overload too small.
reasons 2. The saw is not sharp.
3. The skew of the teeth is not correct.
There are
burns on the
1. The saw is not sharp.
parts being
worked
6. MAINTENANCE AND STORAGE
6.1. Inspections and maintenance
6.1.1. Security instructions
Equipment will only function properly if it is well cared for and maintained. Improper care and
maintenance can cause accidents and injuries.
Possible solution
1. Check the cable and power. Go to an
electrician.
2. Wait 5-10 minutes and reboot.
1. Have the brake replaced at a
maintenance and service center
1. Have only a qualified electrician
replace the thermal sensor.
2. Wait for the engine to cool down and
start again after 5-10 minutes
1. The cable must have dimensions of
1.5mm2.
2. Sharpen the saw
3. Please go to an expert to ensure the
skew of the teeth.
1. Sharpen or replace the saw.
13
EN