Original accessories/attachments
■
Use only the additional equipment and acces-
sories specified in the operating instructions.
Using accessories other than those recommended
in the operating instructions can lead to a risk of
injury .
Use
Connecting the appliance
■
The product may only be operated using
cleaned, condensate- and oil-free compressed
air and may not exceed the maximum operating
pressure stated in the section entitled "Technical
data" on the appliance .
■
To ensure that you can regulate the air pressure,
the compressed air source should be equipped
with a (filter) pressure reducer .
You will need a flexible compressed air hose with
a quick coupling and a suitable compressed air
source to operate this appliance .
♦
Set the working pressure on the filter pressure
reducer of the compressed air source to the
working pressure stated in the section entitled
"Technical data" .
♦
Screw a 1/4" connector nipple 5 into the
compressed air connection 2 .
♦
Slide the connection of the supply hose over
the quick connector of the 1/4" connector
nipple 5 so that it clicks into place .
■
4
│
GB │ IE
Operating the compressed
air blow-out gun
Switching on:
♦
To switch the compressed air blow-out gun on,
press the trigger 1 and keep it pressed .
Switching off
♦
To stop operation, release the trigger 1 of the
compressed air blow-out gun .
Fitting attachments on the
compressed air blow-out gun
♦
Screw one of the desired attachments 4 into
the tool holder 3 of the compressed air
blow-out gun .
Application range of the attachments
The various attachments 4 are primarily suitable
for inflating tyres, balls, air mattresses or similar
items . Before installing the attachment, check that it
fits the valve in question .
In addition, the attachments 4 can be used to
blow out hard-to-reach areas .
Thread sealant strip
The thread sealant strip 8 can be used as an
additional seal . To do this, wrap the thread of one
of the attachments 4, for example .
Storage
♦
Store compressed air appliances only in dry
rooms .