CEILING FAN WITH LIGHT
FIG 9
Motor Wires
Downrod Stand
Cover
9. (FIG 9) Thread the motor wires through the downrod stand cover and canopy, as shown. Then thread the
wires trough the hanger ball.
10. (FIG 10) Tighten the ground wire screw. Slide the pin in, slide the hanger ball up into position.
FIG 11
11. (FIG 11) Tighten the hanger ball screw to the downrod.
12. (FIG 12) Hang the fan on hanger bracket, and make sure the slot of hanger ball is snapped into the chip
of hanger bracket exactly.
FIG 10
Hanger Ball
Canopy
FIG 12
EN
Hanger Bracket
Slot
Tab
13