Publicidad
Step 14
Step
st
1
-Carefully stand your unit upright against the wall in its fi nal location. Strike a mark through the center of the hole in
å
the UPPER FRAMES (M). Lay your unit down.
2
nd
-Drill a 5/16" hole on the marks.
å
rd
3
-While you squeeze the wings together, gently tap two WALL ANCHORS (9) into the holes until they are even with
å
the surface of the wall.
Stand your unit upright placing the brackets in the UPPER FRAMES (M) over the WALL ANCHORS (9).
å
Turn two 2" PAN HEAD SCREWS (15) through the holes in the UPPER FRAMES (M) and into the WALL ANCHORS (9).
å
NOTE: You will need to turn the 2" PAN HEAD SCREWS (13) multiple turns to completely tighten and secure your unit
å
to the wall.
Mark and drill a
5/16" hole into
the wall.
13
2" PAN HEAD SCREW
(2 used in this step)
Page 20
Mark and drill a
5/16" hole into
the wall.
9
M
nd
2
rd
3
M
st
1
Publicidad
