Publicidad
Idiomas disponibles
Idiomas disponibles
1605A00164 GDS18V-330C 20220224.qxp_GDS18V-770 2/25/22 1:25 PM Page 12
Assembly
Model GDS18V-330PC Only - is equipped
Fig. 6
GDS18V-330PC
with a 1/2" square drive (1) with detent pin
(2) (Fig. 6). The detent pin is a spring
loaded pin securing the socket to the
(2)
output drive.
To Install a socket, align the through-hole
on the socket with the detent pin (2) on
the output drive. Depress detent pin and
push socket (10) completely onto output
drive (1).
To remove, depress detent pin (2) with
(1)
pointed object (e.g. a nail) via socket
(10)
through-hole and pull socket off the output
drive.
Belt clip
When
the
tool
is
attached to the belt,
position yourself to avoid entanglement
with surrounding objects. Unexpected
entanglement could cause the tool to fall
resulting in injury to the operator or
bystanders.
The use of the belt clip is optional. When
attached to the tool, the tool may be
supported by the user's belt. This feature
will allow you to have both hands free
when climbing a ladder or moving to
another work area.
The belt clip (4) (Fig. 1) can be attached to
either side of the tool by securing it with a
mounting screw. Always make sure you
tighten the mounting screw before using
the belt clip.
To use the belt clip, turn tool upside down
and attach to your belt.
12
Publicidad
