Publicidad
Idiomas disponibles
Idiomas disponibles
reWinDing SpOOl
(uSe Only .065 in. rOunD DiaMeter line)
(figureS r, S, & t)
nOte: hand wound spools from bulk line are likely to
become tangled more frequently than factory wound spools.
For best results, factory wound spools are recommended.
To rewind spool, follow the steps below:
• Remove battery from tool.
• Remove the empty spool from the tool as described in
replacing the SpOOl".
• Make a fold at the end of the cutting line at about 3/4 inch
(19mm)(R1). Feed the cutting line into one of the line
holding slots (R2) as shown in figure r.
• insert the 3/4 inch (19mm) end of the bulk line into the hole
(S1) in the spool adjacent to the slot as shown in figure
S. Make sure the line is pulled tight against the spool as
shown in figure S.
• Wind the cutting line onto the spool in the direction of the
arrow on the spool. Make sure to wind the line on neatly
and in layers. Do not crisscross (figure T).
• When the wound cutting line reaches the recesses (s2),
cut the line. (figure S).
• Fit the spool onto the tool as described in
"replacing the SpOOl".
Maintenance
Warning:
To avoid serious injury, remove the battery from the
tool before performing any maintenance.
1. keep the air intake slots clean to avoid overheating.
2. your trimmer line can dry out over time. To keep your line in top
condition, store spare pre-wound spools or bulk line in a plastic,
sealable bag with a tablespoon of water.
3. Plastic parts may be cleaned by using a mild soap and a damp rag.
4. The line cutter on the edge of the guard can dull over time. it is
recommended you periodically touch-up the sharpness of the blade
with a file.
This device complies with part 15 of the Fcc rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
nOte: This equipment has been tested and found to comply with the limits for a class b digital device,
pursuant to part 15 of the Fcc Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. however, there is no guarantee that interference
will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• R eorient or relocate the receiving antenna.
• i ncrease the separation between the equipment and receiver.
• c onnect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• c onsult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment. This class b digital apparatus complies with
canadian ices-003.
r
S
12
r2
S2
S1
T
r1
Publicidad
