Publicidad
Idiomas disponibles
Idiomas disponibles
problem
• automatic line
feed does not feed
more line.
• Overfeeding
• line unravels
when cap or spool
is removed.
possible cause
• line not wound properly.
• spool may be damaged.
• Not enough line remaining.
• line may be too long.
• Trimmer is being held at too sharp
an angle.
• line is not restrained when
removing.
possible Solution
• ensure that the line is not
crisscrossed on the spool as
detailed in figure T. If it is, unwind
the cutting line, then wind it back
on the spool neatly so that the
lines do not cross.
• inspect tracks at the bottom of
spool for damage. If damaged,
replace spool.
• Read the code on the back
• pull the cutting line until it
protrudes approximately 4-13/16
inches (122mm) from the spool.
If insufficient cutting line is left on
the spool, install a new spool of
cutting line.
• if the cutting line protrudes beyond
the trimming blade, cut it off so
that it just reaches the blade. If the
automatic line feed still does not
work or the spool is jammed, try
the following suggestions:
• carefully clean the spool and
• Remove the spool and check
• Remove the spool and unwind
• ensure you are not exceeding a
10° angle as shown in figure M1
• Make sure to park the lines in
holding slots (R2) figure r before
removing.
14
of spool. if it reads "pa66"
call customer service for a
replacement. if it reads "abs"
this is not the issue.
housing.
if the lever in the spool housing
can move freely.
the cutting line, then wind it on
neatly again.
Publicidad
