Hkoenig v24 Manual De Instrucciones página 15

and pressing the steam
lmprints left in carpets by furniture can be removed by applying
steam on the parts where the pile is crushed and the brushing
lightly.
_I f the carpet is made of synthetic material, do not select a high
temperature.
How to get a professional ironing finish
A normal iron generates only a small quantity of steam. ln this case it is necessary to products
steam constantly in order to eliminate crease in the fabric being ironed.
A professional ironing system works rather differently. The fabric is first made damp by the steam
and then, in a second
is removed and your garments are ironed to perfection.
the first phase (steam-damping of the fabric),hold the ira about 20 cm above the fabric and
ln
press the steam(3). Pass the iron over the garment in a circular movement so that the powerful
jet of steam damps the fabric. Lightly creased garments require only a few moments of
While very heavy fabrics or garments with particularly difficult creases must be
must be applied for a few seconds
During the second phase (dry
for the type of fabrics; release the steam button(3) and dry-iron the garment. The special ironing
plate will prevent the fabrics from becoming shiny. Using this ironing
suggestions in the chart
professional ironing finish.
button.
phase, dry-ironed in the normal way. This means that
more.
ironing), check that the thermostat knob is in the correct position
below, you find it easy to give your garments a really
will
every. Tiniest crease
steaming.
damper, so steam
technique, and following the