Publicidad
Idiomas disponibles
Idiomas disponibles
Install Warming Drawer Deflector Kit
(Only for Ovens Installed Above
Warming Drawers)
On single and double oven models installed above a warming
drawer, a warming drawer deflector kit must be installed. See the
"Tools and Parts" section for information on ordering.
Parts Supplied in Deflector Kit
A. Phillips head screws (4), only 2 screws for 27"
(68.6 cm) size
B. Warming drawer deflector (1)
Install Deflector Kit
1. Install the warming drawer deflector (B) to the lower vent
piece (D) using two #8-18 x 1/4" (6.4 mm) screws on each
side.
NOTE: On 27" (68.6 cm) models, only one #8-18 x 1/4"
(6.4 mm) screw is used on each side.
B
C
D
#8-18 x 1/4" (6.4 mm)
A.
screws
Warming drawer deflector
B.
2. Align vent tab (B) with oven frame (A) as shown in the
following illustration.
20
A
A
Upper vent piece
C.
Lower vent piece
D.
3. Using one #8-18 x 3/8" (9.5 mm) screw (E) on each side of the
vent tab (B), fasten the vent securely to the oven.
B
Replace Oven Door(s)
1. Using two hands, grasp side edges of door at the midpoint.
Face the oven cavity.
2. Locate the slots on each side of the oven cavity for the door
hinge locks.
3. Using 2 hands, grasp the edges of the oven door. At a 45°
angle, insert the hinges at the same time, and push the oven
door into the oven cavity slot to replace. You may need to
gently shift the door from side to side as you push.
E
D
C
A. Oven frame
Warming drawer deflector
D.
#8-18 x 3/8" (9.5 mm)
E.
B. Vent tab
screw
C. Oven vent
A. Slot in the oven cavity for door hinge lock
A
B
Publicidad
