Publicidad
Idiomas disponibles
Idiomas disponibles
SAVE
LOAD
RANGE
SELECT
Display indicators are shown in Figure 4 and described in Table 5.
28
Press this button to store the single record.
Press and hold this button to store data continuously. Press SAVE again to exit
The maximum number of data store is 99 sets. The Meter displays FULL when it
reaches the maximum. Press CLR to clear the stored data in order to store next
•
Press this button once to recall the stored value. Press or to recall the
previous or next stored value. Press LOAD again to exit data recall mode.
•
Press and hold this button to recall the stored data continuously. Press
•
After entering the Load mode, it is not allowed to turn the rotary switch to
enter to measuring mode. You can only enter the measuring mode after exiting
In Measurement mode, except buzzer, diode and insulation test, press to start
In Load, each press to go back to the previous stored reading
In Measurement mode, except buzzer, diode and insulation test, press to start
In Load, each press to recall the next stored reading.
In Insulation Test mode, press to select different testing voltage.
In other mode, except buzzer and diode, press to change Ranging mode from
Auto to Manual Ranging mode. Press and hold to return to Auto Ranging mode.
Functions as a shift key. Press to access orange functions on the rotary switch.
Initiates an insulation test when the rotary switch is on the INSULATION position.
Causes the Meter to source (output) a high voltage and measure insulation
InMeasurement mode, activate frequency measurement.
UNDERSTANDING THE DISPLAY
Figure 4. Display indicators
continuous data storing mode.
set of data
LOAD again to exit.
the Load mode.
retaining maximum value.
retaining minimum value.
resistance.
Publicidad
