Publicidad
Idiomas disponibles
Idiomas disponibles
Warning
To avoid electric shock, injury, or damage to the Meter, disconnect circuit power and
discharge all high-voltage capacitors before testing capacitance. Use the DC Voltage
function to confirm that the capacitor is discharged.
The Capacitance ranges are 10.00nF, 100.0nF, 1000nF, 10.00µF and 100.0µF
To measure capacitance, connect the Meter as follows:
1. Insert the red test lead or red short lead with alligator clip into the
black test lead or black short lead with alligator clip into the COM terminal. If the capacitor being
tested has polarity, connect the positive into the terminal and the negative into the COM terminal
2. Set the rotary switch to
3. Connect the test leads across with the object being measured. The measured value shows on
the display.
Note:
• When Capacitance measurement has been completed, disconnect the connection between
the testing leads and the circuit under test, and remove the testing leads away from the input
terminals of the Meter.
Testing for Continuity (see figure 10)
34
MEASURING CAPACITANCE (see figure 9)
Figure 9. Measuring Capacitance
Press SELECT button to select capacitance measurement mode
terminal and the
Publicidad
