STORZ & BICKEL Crafty+ Modo De Empleo página 57

Disregarding this may allow plant
i
particles to enter the Cooling Unit,
so blocking this or be inhaled.
7.2 Screens
K After each vaporization, clean the
Screens with the enclosed Clean-
ing Brush.
7.3 Filling Chamber
Ká 3é 'wswééf,ó áP svwf' ágw ¼ v v3'p
i
chamber as soon as the lower
Screen is clogged.
7.3.1 Removing the lower Screen
K Remove the lower Screen by press-
3'p3áfvP'págwp,PPzw3'ágw¼ v v3'p
chamber using the Filling Cham-
ber Tool. This causes the lower
Screen to bulge and detach from
the groove.
7.3.2 Cleaning
K lyBgU K.B ¼ y y&UD 5.gä4BE ®&K. g
cotton swab soaked in isopropyl
alcohol.
Make sure that no isopropyl alcohol
i
drips into the interior of the device.
7.3.3 Installing the lower Screen
K Curve the lower Screen. I
á K'éw,áágwvPJw,Us,ww'3'áPágw¼ v v -
ing chamber with the curved side
facing upwards.
7 C L E A N I N G
á Using the Filling Chamber Tool,
7,wéé ágw és,ww' ½ f á 3'áP ágw 7,P -
vided groove.
if7P,39w, f'l
D'J CS
Material damage caused by
&ä•EL•BE 5y BgU&UD
Water may penetrate and damage
the Vaporizer or USB-C Cable
• Do not immerse in water or
other liquids
• Do not clean with a direct water
LE 8KBgäG BK LE5Lä•EB88B6
air
á Disconnect the USB-C Cable from
the power source.
á Switch off the Vaporizer.
á Clean the housing of the Vaporiz-
er and the USB-C Cable only dry
or at most with a damp cloth if
necessary.
57
WUO R Rfkvw