Publicidad
Idiomas disponibles
Idiomas disponibles
• Unscrew the fuel valve (set to the "ON" position) and pour the
remaining fuel out of the tank.
• Screw the screw on the bottom of the carburetor drop tank back in.
• Replace the engine oil with fresh oil.
• Remove the spark plug (located under the ignition cable pipe - see
image below) and pour a little fresh engine oil through its hole in the
engine.
Then turn the starter motor several times to distribute the oil in the
cylinder. Reinstall the spark plug in the engine.
• Cover the pump to protect it from dust and sunlight.
3.4.
Cleaning and maintenance
a)
Before cleaning, adjustment, replacement of accessories, and when the unit is
not in use, turn off the engine and cool the unit completely.
Wait until the rotating parts stop.
•
b)
Use only non-corrosive cleaning agents for cleaning the surfaces.
c)
Store the unit in a dry and cool place protected from moisture and direct
sunlight.
d)
Do not spray the unit with a stream of water or immerse it in water.
e)
Make sure that no water enters through the ventilation openings in the casing.
f)
Clean the ventilation openings with a brush and compressed air.
g)
Perform regular inspections of the unit checking technical fitness and any
damages.
Publicidad
