Wiesenfield WIE-CLI-200 Manual De Instrucciones página 26

Horse or cattle hair can become lodged between the cutting head
blades if the pressure is incorrectly adjusted with the tensioning nut
before operation. In this case it is necessary to switch off the device,
unplug it from the mains and carry out maintenance work. Dismantle the
cutting head blades, clean the moving parts, oil them and reassemble
them. Readjust the pressure of the cutting head blades.
3.3.3. MAINTENANCE OF CUTTING HEAD COMPONENTS
To maintain proper function and extend the life of the unit maintenance of the
cutting head parts is required. Use a thin layer of oil on the cutting blades (C)
and comb plate (E) and pour a few drops of oil into the lubrication holes (D)
located on the cutting head.
CAUTION!
ISO VG15. Do not use WD40! Exchange the parafin oil every 21 days!
The oil provided by the supplier is non-toxic and does not cause irritation to
skin or mucous membranes.
When using the unit, care should be taken to constantly moisten the moving
parts of the cutting head (cyclically, every 3-5 minutes). Insufficiently oiled or
Use only oil provided by the supplier or paraffin oil according to