cecotec READYWARM 9600 SMART FORCE Manual De Instrucciones página 29

Setting timer
- The device includes a 24-hour programmable timer.
- The timer can be set from 1 minute to 23 hours 59 minutes.
- Once the programmed time has elapsed, the device switches off and the word END
appears on the display.
1. Press the Timer button. The hour indicator will blink.
2. Press the + and – buttons to set the desired hour.
3. Press the Timer button again.
4. Press the + and – buttons to set the desired minutes.
5. Press the Timer button to save the timer settings.
6. The set time will show up on the display.
Oscillation function
Press the oscillation button to activate and deactivate the oscillation function. The device
oscillates from one side to another, spreading warm air.
Protection against overheating
- The device turns automatically off when its temperature becomes too high. If this
happens:
- Turn off the power switch.
- Allow the device to cool down.
- Check if the air inlet or outlet is obstructed and clean it.
Safety switch
The device includes a tip-over safety system that automatically turns off the device when it
tilts or when it is lifted.
Frost protection
When this function is activated, the device automatically turns off when the room
temperature falls below 6 ºC and will remain on until it reaches 9 ºC. Press the mode button
repeatedly until the frost protection mode symbol appears on the display to activate it and
press again to deactivate it.
4. CLEANING AND MAINTENANCE
- Turn off and unplug the appliance and allow it to cool down before cleaning it.
- Do not use abrasive cleaners or scouring pads to clean the product.
- Use a soft, dampened cloth to clean the product's outer housing. Be careful not to touch
the heating element.
READYWARM 9600 SMART FORCE
ENGLISH
29