CITYSPORTS CS-WP5 Manual Del Usuario página 12

Suggestion:
ALIGN AND TIGHTEN THE BELT OF THE TREADMILL
< 3 hours/week
4 – 7 hours/week
> 8 hours/week
ALIGN THE BELT: Due to its use, the belt can move off center. If the
belt has moved to the left, start treadmill and increase the speed to
3km/h .Use the 6mm Wrench to turn the fixed left bolt clockwise or
turn the fixed right bolt counterclockwise. Don't tighten the belt too
much in order to be able to walk. Repeat this procedure until the
belt is properly aligned.
If deviate to the left,
then adjust the screw
on the left side
clockwise or the screw
on the right side
anticlockwise.
TIGHTEN THE BELT: (if the belt slips on the treadmill when walking).
Start treadmill and increase the speed to 3MPH.Using the 6mm
Wrench , turn both bolts 1/4 clockwise. If the belt is properly tight
to walk, you must be able to pull up each side of the belt 5 or 7 cm
off the platform. Be careful and maintain the belt aligned. Repeat
this procedure until the belt is properly tightened.
Https://www.LikeSporting.com
2 months
1 month
15 days
if the running belt slips,use 6mm
wrench,turn both sides bolts 1/4
clockwise.Repeat this procedure
until the belt is properly tightened.
- 10 -
If deviate to the right,
then adjust the screw
on the right side
clockwise or the screw
on the left side
anticlockwise.
ＥＮ