Publicidad
Idiomas disponibles
Idiomas disponibles
Forward Facing Installation
Group 2 (15kg to 25kgs)
15 - - 25
15
25
Attention:
Please store the 5 point harness system underneath the seat fabrics when
using Group II (15-25kg)
FORWARD FACING
19
NOTE: Only use this configuration once the child's weight exceeds the minimum
weight range and their shoulder height is above the maximum harness height
position.
1. Remove the infant head and body inserts and pillow. First unclip and loosen the
harness and then pull out the inserts from around the harness before then removing
the pillow. This is shown in images D-1, D-2 and D-3.
2. Remove the buckle and buckle pad. To remove the crotch buckle pad, pull
and slide it off the buckle as shown in image D-3. To remove the buckle, reach
underneath the seat (it is helpful to adjust the seat into maximum recline to improve
access) and thread the retaining clip back through the slot as shown in image D-4.
The buckle should now be separated from the seat.
3. Store the shoulder straps and pads behind the seat fabric panels. First release
the 6 press studs located around the harness as shown in image D-5. Push the
headrest back panel up and over the headrest and pull the lower back panel
forward over the buckle slot. Thread the harness and buckle tongues behind the
panels, positioning them flat and then resecure the press studs.
4. The child will now be secured with the vehicle seatbelt or lap-sash belt, with
the sash portion crossing over their chest starting at their door side shoulder and
finishing on their opposing waist side – clipped into the buckle. The lap belt will cross
over the waist, beginning at their door side and finishing on the opposing as shown
in images E-1 and E-2.
5. Thread the shoulder or sash portion of the vehicle seatbelt through the red belt
hook - closest to the retractor and then through the headrest clip as shown in
image E-3.
20
Publicidad
