Publicidad
Idiomas disponibles
Idiomas disponibles
6. ADJUSTMENT OF CUTTING HEIGHT
Apply outward pressure to disengage lever from rack. Move lever forward or back to adjust height.
The height (the blade to the ground) can be adjusted from 25mm to 75mm , 7 height positions.
(Fig.8).
WARNING: Make this adjustment only when the blade is stopped.
WARNING: Disconnect the electric cord from the power supply.
7. "2 IN 1"
These lawn mowers can be retrofitted from its normal function, based on the application purpose:
From lawn mower with rear discharge to mulching mower
What is mulching?
When mulching, the grass is cut in one working step, then finely chopped and returned to the grass
strip as natural fertilizer.
Hints for mulch-mowing:
- Regular cut-back by max.2cm form 6cm to 4cm grass height.
- Use a sharp cutting knife - Do not mow wet grass
- Set max. Motor speed
- Only move at working pace
- Regularly clean mulching wedge, housing inner side and mowing blade
Starting Operation
ONE: Retrofitting for mulching mower
WARNING: only with a stopped motor and standstill cutter.
1. Raise the rear cover and remove the grass catcher.
2.Push the mulching wedge into the deck. Lock the mulching wedge into the opening on the deck.
(Fig. 9A/ Fig. 9B).
3. Lower the rear cover again. (Fig. 9C).
Fig. 8
11
Publicidad
