Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Fig. 2D
Fig. 2G
5.2 Assemble the grass catcher
Assembly the handle into the grass catcher (Fig. 3A/ Fig. 3B/ Fig. 3C)
Insert one end with a projection into the grass catcher, and then fixed another end of the handle
onto the grass catcher with the screw.
1. To fit: Raise the rear cover and hitch the grass catcher on rear of mower. (Fig. 3D/ Fig. 3E/ Fig. 3F)
2. To remove: Grasp and lift the rear cover, remove grass catcher.
There is a level indicator on the top of the grass catcher that shows whether the catcher is empty or
full:
- The level indicator inflates if the catcher is not full during the moving. (Fig. 3G)
- If the catcher is full, the indicator collapses; once this happens stop moving immediately
and empties the catcher, make sure it is clean and ensure its meshwork is ventilated.
(Fig. 3H).
IMPORTANT:
If the position of indicator opening is very dirty, the indicator will not inflate-in this case, clean the
position of indicator opening immediately.
Fig. 3A
Fig. 2E
Fig. 2H
Fig. 3B
8
Fig. 2F
Fig. 3C
Publicidad
