Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
11. MAINTENANCE AND CARE
WARNING: Before performing any Maintenance or cleaning work, Always remove batterys
and switch off the isolator key!
Do not spray the unit with water. Ingress of water may destroy the switch and the electric motor.
Clean the unit with a cloth, hand brush, etc.
Expert inspection is required, do not make any adjustment by yourself, must contact to custo-
mer Service centre:
a) if the lawn mower strikes an object.
b) if the motor stops suddenly
c) if the blade is bent (do not align!)
d) if the motor shaft is bent (do not align!)
e) if a short-circuit occurs when the cable is connected.
f) If the V-belt is defective.
h) Use only manufacturer's recommended replacement parts and accessories.
12. TROUBLESHOOTING
Fault
Motor does not run.
Motor power drops.
Grass catcher is not filled.
Wheel drive does not function.
Machine leaves ragged finish.
Problem
Motor does not run.
Machine leaves
ragged finish.
Remedial action
Turn power on.
Start on short grass or on an area which has already been mown.
Clean discharge channel/housing –the mowing blade must rotate freely.
Correct the cutting height.
Correct the cutting height.
Clean discharge channel/housing.
Have mowing blade resharpened /replaced
Correct the cutting height.
Allow the lawn to dry.
Have mowing blade resharpened /replaced
Clean the grille on the grass catcher.
Clean the discharge channel /housing.
Check the drive wheels for damage.
Height of cut too low, increase height of cut.
Cutting Blade Blunt, have the blade resharpened or replaced.
Possible cause
Power Turn off.
Grass too long.
Blade blocked.
Height of cut too low.
Cutting Blade Blunt.
customer Service centre.
customer Service centre.
Possible solution
Turn power on.
Increase the height of cut and move machine to
shorter grass to start.
Clean discharge channel/housing.
Increase height of cut.
Have the blade resharpened or replaced.
16
Publicidad
