TM Electron TMHC105 Manual De Instrucciones página 7

Caution
Do not use the hair clipper continuously for more than 10 minutes.
The hair clipper is fitted with high quality T10 carbon steel blade that is permanently
lubricated. To ensure long-term performance of your clipper, clean the blades and unit
regularly. Always keep the blade guard on the clipper trimming blade when not in use.
After Each Use:
• Ensure that the clipper is switched OFF and disconnected from mains power.
• Clean the hair from blade with the cleaning brush provided. Do not use water to
clean.
• To clean the clipper, wipe with a damp cloth and dry immediately.
• Do not use liquid cleaners on the blades or harsh or corrosive chemicals on the
clipper.
• To prevent damage to the blade, do not apply pressure or hard objects to the
clipper blades.
BEFORE USING YOUR HAIR CLIPPPER
Your clipper was carefully examined to make sure the blades were oiled and aligned
before leaving our factory.
The blade position is showed with the picture below. If the blades are out of
alignment they can be easily adjusted.
To align the blades, use a screwdriver to loosen the 2 screws retaining the fixed bla-
de. Ensure to adjust the taper lever to the lowest position and align the blades so that
the cutting edges are parallel to one another. Then tighten the 2 screws.
To keep your clipper in good working condition, make sure the blades are oiled as
shown in the picture below. Simply spread 1-2 drops of the supplied lubricating oil on
the four positions shown.
8
INGLÉS