Publicidad
Idiomas disponibles
Idiomas disponibles
To adjust the clipper for good performance, switch the clipper ON and use a screw
driver, or a thin coin, to turn the power screw on the opposite side of ON/OFF switch
in clockwise direction until you hear a loud clattering noise, refer to below photo. Then
slowly turn the power screw anticlockwise until the noise stops. Switch the clipper ON
and OFF a few times to ensure the clattering has stopped. If it continues when the
clipper is switched ON, turn the screw a little further anticlockwise. This is the optimal
setting for the hair clipper blades.
To ATTACH TRIMMING GUIDES
The hair clipper comes with nine clipper guides, which are marked with a number.
Clipper Guide No. 1 leaves a 3mm hair length.
Clipper Guide No. 2 leaves a 6mm hair length.
Clipper Guide No. 3 leaves a 10mm hair length.
Clipper Guide No. 4 leaves a 13mm hair length.
How to use the clipper
To attach a clipper guide, hold it with its teeth upward and slide it onto and along the
clipper blades, then press down gently until it clicks into place, refer to below photo.
Pull the comb upward and away from the clipper blade to remove the guide.
The hair clipper has a taper lever located at the left side of the clipper, near the blade.
The lever adds versatility to your clipper by allowing you to gradually change the clo-
seness of your cut without need for a clipper guide and also to improve the effective-
ness of the trimming guide attachments.
When the level is in the uppermost position (Picture 1), the blades will give you the
9
INGLÉS
Publicidad
