Steinbach Digitales Funk Pool Thermometer Operación Manual página 21

12. Screw the screw
The display elements of the display appear briefly. The measured outdoor temperature is
displayed next to the outdoor temperature symbol
channel display .
7
Indoor unit
Change the batteries of the indoor unit
display.
1. Remove the battery compartment cover from the battery compartment
2. Remove the old batteries.
At delivery there are no batteries in the battery compartment.
3. Insert 2 new AAA batteries.
Never mix batteries with different charge levels. Use only batteries that are listed in the
"Technical Data" section.
4. Close the battery compartment
The display elements of the display appear briefly. The measured indoor temperature is
displayed next to the indoor temperature symbol
approximately 3 minutes while the indoor unit
. As soon as the indoor unit receives the signal from the outdoor unit, the temperature
12
measured by the outdoor unit
Manual transmitter search
When exceeding the transmitter range, the indoor unit
signal of the outdoor unit
the indoor unit is not receiving the signal from the outdoor unit, 3 horizontal lines ("--.-") are
displayed next to the outdoor temperature symbol
In order to restore the wireless connection, it might be necessary to initiate the transmitter
search manually.
Activating the transmitter search manually
1. During the transmitter search, place the indoor and outdoor unit approximately 1.5 m
from possible sources of interference (electronic devices and radio equipment).
2. Repeatedly press the CH button
The channel display
channel switch
3. Press and hold the CH button
The signal symbol
the outdoor unit
The temperature measured by the outdoor unit appears next to the outdoor temperature
symbol as soon as the indoor unit receives the wireless signal via the set channel.
9
Maximum/minimum function
The maximum/minimum function displays the highest and the lowest temperatures measured
since the last time the memory was cleared.
into the tab
19 15
1
with the battery compartment cover.
17
is displayed.
12
(e.g., in the event of a signal failure or after a battery change). If
12
4
(indoor unit) displays the same channel that is set via the
7
(outdoor unit).
23
for 3 seconds.
4
blinks while the indoor unit
8
.
12
(see Fig. C).
. The set channel is displayed by the
9
as soon as the battery symbol appears on the
. The signal symbol
10
searches for the signal of the outdoor unit
1
occasionally loses the wireless
1
instead of the measured temperature.
9
.
searches for the wireless signal of
1
.
17
flashes for
8
21