ProBreeze PB-15 Manual De Instrucciones página 11

OPERATING INSTRUCTIONS
― ―
Control Panel
Buttons
NOTE: for safety reasons and to regulate temperature, the fan will continue to run when the
compressor is off.
• Auto / Comfort: Press once to start auto mode. This will automatically set the room humidity
to 45-55% based on the room's environment.
• Filter: The filter light will flash after 250 hours of operation as a reminder to clean the filter on
the unit. Once cleaned, press the filter button once to reset.
To connect the unit to wifi, hold the filter button down for three seconds until "AP" shows on
the LED display and follow the instructions below.
• Cont: press once to activate continuous dehumidifying mode. Before doing so, connect the
drainage hose to the back of the unit.
• Turbo: press once to start Turbo Mode. This will increase the fan speed to maximum. Press
again to reduce the fan speed.
• Timer: this button controls the auto-start and auto-stop functions.
For auto-start, turn the unit off using the power button. Press the timer button until the "on"
light illuminates.
• Use the arrows to select the auto time (available in 30 minute increments, up to 24 hours).
Once selected, wait five seconds. The LED display will return to blank. The unit will turn on
after the time has been reached.
• For auto-stop, turn the unit on using the power button. Press the timer button until
the "on" light illuminates. Use the arrows to select the auto time (available in 30 minute
increments, up to 24 hours). Once selected, wait five seconds. The LED display will
return to showing the RH. The unit will turn off after the time has been reached.
• Turning the unit on or off, or reducing the time to 0 will turn off timer mode. The unit will
turn off after the time has been reached.
• Up / Down Buttons: press to control the humidity level. The humidity level can be set from
25% RH to 85% RH in 5% increments. For drier air, set a lower RH. For damper air, set a higher
RH.
English | 11 of 124