Descargar Imprimir esta página

Ryobi RYPM8001 Manual Del Operador página 10

Ocultar thumbs Ver también para RYPM8001:

Publicidad

Idiomas disponibles

Idiomas disponibles

„ Adjust the maximum speed selector and press the self-
propelled paddle located on the back of the upper con-
trols to increase the speed.
MAXIMUM SPEED SELECTOR
See Figure 12.
WARNING:
Always adjust the speed selector before you engage the
blade. Adjusting the speed selector while mowing may
cause you to lose control and could result in serious injury
while the blade is operating.
WARNING:
When using the self-propelled feature, ensure that the
speed selector is set at a speed that you can comfortably
follow when walking behind the mower. You may lose con-
trol of the mower if the speed selector is set at a speed that
is too fast for your walking pace. Release the self-propel
paddle and bail if you cannot keep up with the mower and
adjust the speed selector as needed. Failure to follow these
instructions can result in serious personal injury.
While using the self-propelled feature, the maximum speed
of the mower can be set using the speed selector switch.
„ Slide the switch on the top of the handle to the left to
decrease your maximum speed, slide the switch to the
right to increase your maximum speed.
„ The self-propelled paddle allows you to control the drive
speed between 0mph and the maximum speed selected.
BLADE REPLACEMENT INDICATOR
See Figure 12.
The blade replacement indicator light turns red after a certain
amount of hours/uses indicating it is time to change the blades.
Refer to Replacing the Cutting Blades in Maintenance.
To reset:
„ Reinstall the start key and reconnect the battery pack's
quick connect plug
„ Press and release the start button five times within ten
seconds to reset.
MOWING TIPS
WARNING:
Do not mow on wet grass, which can cause you to slip
and fall and result in possible serious personal injury.
NOTE: Fully charge battery before each use for optimal
runtime.
„ Make sure the lawn is clear of stones, tree nuts, sticks,
wires, and other objects that could damage the lawn
OPERATION
mower blades or motor. Do not mow over property
stakes or other metal posts. Such objects could dam-
age the blades or be accidentally thrown by the mower
in any direction and cause serious personal injury to the
operator and others.
„ For a healthy lawn, always cut off one-third or less of the
total length of the grass.
„ When cutting heavy grass, reduce walking speed to al-
low for more effective cutting and a proper discharge of
the clippings.
„ Do not cut wet grass. It will stick to the underside of the
deck and prevent proper bagging or mulching of grass
clippings.
„ New or thick grass may require a narrower cut or a higher
cutting height.
„ Clean the underside of the mower deck after each use
to remove grass clippings, leaves, dirt, and any other
accumulated debris.
„ NOTE: Always stop mower, allow blades to completely
stop, remove the start key and remove the battery packs
from the battery port before cleaning underneath the
mower.
SLOPE OPERATION
See Figure 14.
WARNING:
Slopes are a major factor related to slip and fall accidents
that can result in severe injury. Operation on slopes
requires extra caution. If you feel uneasy on a slope,
do not mow it. For your safety, do not attempt to mow
slopes greater than 15 degrees and mow across the face
of slopes, not up and down.
„ Mow across the face of slopes, not up and down. Exer-
cise extreme caution when changing direction on slopes.
„ Watch for holes, ruts, rocks, hidden objects, or bumps
which can cause you to slip or trip. Tall grass can hide
obstacles. Remove all objects such as rocks, tree limbs,
etc., which could be tripped over or thrown by the blades.
„ Always be sure of your footing. A slip and fall can cause
serious personal injury. If you feel you are losing your bal-
ance, release the upper blade control lever immediately.
„ Do not mow near drop-offs, ditches, or embankments;
you could lose your footing or balance.
BLADE/CUTTING OPTIONS AND BATTERY
RUNTIME
This mower offers two cutting options - combination blade
and cross cut combo dual blades. The blade/cutting option
used will affect the battery runtime. The combination blade
will provide the longest runtime.
10 — English

Publicidad

loading