Publicidad
OPERATING INSTRUCTIONS
c.
Turn the tank over, then turn the black rubber cover counterclockwise, and remove it. After
filling the tank with water, turn the black rubber cover clockwise to seal the tank.
d. Install the water tank: push the water tank (J) down until you hear a "click"; or press the
water tank install/release button (L), push the tank down, then release the button to lock
the tank in place.
NOTE:
• The tank can store 16oz (454mL) of water. Use only clean tap water. Do not add chemicals
or detergents to the water.
• The water will automatically feed during the cutting process. The translucent tank makes it
easy to monitor the remaining amount of water.
• The tank that is not fully locked in place will not supply water.
• If the tank is not properly installed or the water is not supplying properly, remove the black
rubber cover and check whether the rubber cover is blocked or coated with foreign matter.
WARNING
• Your tool is not suitable for direct connection to the water pipe.
• Refill the tank each time the water is nearly used up.
• Do not cut with the water tank empty. This will damage the cut-off wheel and overload
the saw.
4. Turning the Tool On/Off
a. To turn the tool on: attach the battery pack;
push the lock-off button (A) fully to either side
until it snaps into place, then depress the
trigger switch (B).
b. When the saw starts, release the lock-off
button (A).
c.
To turn the tool off, just release the trigger
switch (B).
5. Adjusting the Cutting Depth
a. Turn off the tool and remove the battery pack.
b. Raise the depth-adjustment lever (F) to release
it.
c.
Hold the base (E) against the workpiece
and raise or lower the saw until it gets to the
desired depth on the depth scale (G).
d. Lower the depth-adjustment lever (F) to lock
the saw at the desired depth of cut.
4
5
14
A
B
C
F
G
E
Publicidad
