Publicidad
Idiomas disponibles
Idiomas disponibles
B
Product usage
4)
Pass the thread through the take-up lever
from right to left. If you cannot see the take-
up lever, turn the handwheel towards you
(anticlockwise) to raise the take-up lever to
the highest position.
5)
Pass the thread through the thread guide
above the needle.
6)
Then thread the thread through the eye of the
needle from front to back.
Pulling the bobbin thread (lower thread)
After threading the upper thread and inserting the bobbin, the bobbin thread must be pulled
out before the sewing process can begin.
1.
Make sure that the on/off switch is set to "OFF" and the machine is unplugged from the
mains socket.
2.
Raise the presser foot lifter (1).
To open the bobbin cover, push the bobbin cover release button to the right (2).
3.
4.
Insert the threaded bobbin into the bobbin case, leaving the tail of the thread on the left.
Make sure that the bobbin turns anticlockwise (3) when pulling the thread from the left.
5.
Hold the upper thread with your left hand and turn the handwheel towards you
(anticlockwise) with your right hand to lower the needle (4) (5). Keep turning it until the
needle rises to the highest position.
6.
Pull the upper thread upwards to pull the bobbin thread through the throat plate (6).
7.
Pull both threads through the throat plate and position them under the presser foot
(towards the rear of the machine), leaving a thread tail of approx. 15 cm for both threads (7).
Close the bobbin cover (8).
8.
50
EN
Publicidad
