Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
3. No water cooling
4. Machine suddenly
stops during use
5. Low efficiency
cutting
6. Strong vibration,
unexpected noise,
strong smell
10. DISPOSAL AND RECYCLING
The equipment is supplied in packaging to prevent it from being damaged in transit. The raw materials
in this packaging can be reused or recycled.
The equipment and its accessories are made of various types of material, such as metal and plastic.
Defective components must be disposed of as special waste. Ask your dealer or your local council.
For EU countries only
Never dispose of any electric power tools with your household refuse. To comply with
European Directive 2012/19/EU on waste electric and electronic equipment, and its
implementation in national laws, old electric power tools must be separated from other
waste and disposed of in an environment-friendly fashion, e.g. by taking them to a
recycling depot.
Recycling alternative to returns
As an alternative to returning the equipment to the manufacturer, the owner of the electrical
equipment must make sure that the equipment is properly disposed of if he no longer wants to keep
the equipment.
Old equipment can be returned to a suitable collection point that will dispose of the equipment in
accordance with national recycling and waste disposal regulations.
Electric and electronic equipment can be hazardous for the environment and for human health since
they contain hazardous substances.
This does not apply to any accessories or aids without electrical components supplied with the old
equipment.
Possible reason
• Twisted, bend or damaged cooling
water pipe
• Too little cooling water in container
• Blocked pumping sieve
• Blocked pump
• Other fault or electric error in the
pump
• Power supply broken
• Cutting disc blocked
• Extension cord too long and / or
with too small diameter.
• Power supply (e.g. generator) has
too low current.
• Exceed maximum cutting depth
• Cutting disc unsuited or wrong
direction of rotation
• Unplug immediately! Cutting disc is
not being cooled, wrong mounted
or worn
• Unplug immediately! Other fault.
Remedy
• Check the running of cooling water,
remove blocking if needed or
exchange the pipe
• Fill in cooling water to cover the
pump
• Clean the sieve
• Test the pump, clean remove
blocking
needed
• Test the power supply with a
different device
• Unplug immediately! Remove
blocking carefully, afterwards test
cutting disc
• Use extension cord with allowed
length and/or sufficient diameter.
• Connect the device to different
power supply
• Check the maximum cutting depth
• Test cutting disc for type of use,
condition and rotation direction
• Test cooling, cutting disc mounting
and direction of rotation, if needed
mount a new, suitable cutting disc
132
FR
ES
PT
IT
EL
PL
UA
RO
EN
Publicidad
