Installation
Proper clearance enhances the cooling! efficiency of the unit and prevents heat
radiation of the condenser.
1. If a storm window presents interference,
fasten a 2" wide wood strip to the inner
window sill across the full width of the sill. The wood strip should be thick
enough to raise the height ,of the window sill so that the unit can b,e installed
without interference
by the storm window frame.
2.. See Figure. B. The top of the wood strip should be, approximately
3/4" higher
than the storm window frame (Storm Window Rame) or wood strip (Outdoors)
to help ,condensation to drain properly t,o the outside.
3. Install a second wood strip (approximately
6" long by 11/2" wide and same
thickness as first strip) in the center of the sill flush against the back off the
inner sill. This will raise the L bracket as shown Figure. B.
4. If the distance between Storm Window Frame and Wood Strip Mounted on Top
of Inner Sill is more than 1", two of wood strips are not necessary.
Inner Si_l
indoors
Figure, A
Figure, B
12
Room Air Conditioner