Shop-Vac SL Serie Manual Del Usuario página 10

without a filter will cause dust
to discharge from blower port
and cause damage to motor.
INSTALLING AND
CLEANING THE
CARTRIDGE FILTER
WARNING!
ALWAYS DISCONNECT THE PLUG
FROM THE WALL OUTLET BEFORE
REMOVING THE TANK COVER.
NOTE: If foam sleeve (Not
standard with all models) is
installed on lid cage, remove
before installing the cartridge
filter.
14. The cartridge filter can be
used for dry pick up and
small quantities of wet pick
up. Installation is the same
for both. When picking up
large quantities of water we
recommend using a foam
sleeve (Not standard with
all models) instead of the
cartridge filter. When picking
up fine dust or powders a
high efficiency filter bag (Not
standard with all models)
9 Eng.
must be used with the
cartridge filter.
NOTE: If cartridge filter has
been used for wet pick up, it
must be cleaned and dried
before using it for dry pick up.
15. With the tank cover in an
upside down position, slide
the cartridge filter down over
the lid cage, pushing until the
filter seals against the cover.
(FIGURE 10)
FIGURE 10
16. Place the filter retainer into
the top of the cartridge filter.
(FIGURE 11)
FIGURE 11
17. Hold the tank cover with one
hand, turn the handle on the
filter retainer clockwise to
tighten, locking the filter into
place. (FIGURE 12)