Shop-Vac SL Serie Manual Del Usuario página 8

CASTER/
DOLLY SYSTEM
ASSEMBLY
1. You will find two caster
assemblies, one dolly assembly
and four screws with your wet/
dry vacuum. (FIGURE 1)
FIGURE 1
2. With cord disconnected from
receptacle and tank cover
removed, turn tank upside
down so that bottom is facing
up. Remove any webbing that
attaches the caster feet to
each other.
3. Take rear caster dolly and
place into slots (on rear of
tank, opposite of inlet) and
secure with screws provided.
(FIGURE 2)
FIGURE 2
7 Eng.
ASSEMBLY
4. With tank inlet facing you, take
the caster assembly marked
with the letter A (FIGURE 3)
and place in the slot on left
side of the tank, also marked
with the letter A. Secure with
screw provided. (FIGURE 4)
FIGURE 3
5. Take caster assembly marked
with the letter B (FIGURE 5)
and place in the slot on right
side of the tank, also marked
with the letter B. Secure with
screw provided. (FIGURE 6)
FIGURE 5
6. With tank inlet facing you,
attach hose holder A to caster
assembly A, and hose holder B
to caster assembly B.
(FIGURE 7)
FIGURE 4
FIGURE 6