Shop-Vac SL Serie Manual Del Usuario página 14

service. To use the foam
sleeve; follow the installation
instructions in this section.
34. Misting in the exhaust air or
dripping of liquid around the
tank cover may occur if the
filter becomes saturated during
wet pick up. If this occurs,
remove the filter and allow to
dry, or replace with another
dry filter.
35. Turn the unit off immediately
upon completing a wet pick
up job or when tank is full and
ready to be emptied. When
the tank is full, suction will
drastically reduce. Refer to
"automatic suction shut off"
in this manual. Raise the hose
to drain any excess liquid into
the tank. Follow the "emptying
liquid waste" section in this
manual.
36. Before storing the vacuum
cleaner or using for dry pick
up, clean and dry the interior of
the tank and the underside of
the tank cover. Clean and allow
the filters to dry completely.
NOTE: WET PICK UP
ACCESSORIES SHOULD BE
WASHED PERIODICALLY;
ESPECIALLY AFTER PICKING
UP WET, STICKY KITCHEN
ACCIDENTS. THIS CAN BE
ACCOMPLISHED WITH A
WARM SOLUTION OF SOAP
AND WATER.
13 Eng.
FOAM SLEEVE
INSTALLATION
AND CLEANING
37. With tank cover in an upside
down position, slide the foam
sleeve down over lid cage
pulling until foam sleeve
completely covers lid cage.
(FIGURE 22)
FIGURE 22
38. To clean the foam sleeve,
disconnect the plug from the
wall outlet. Remove the tank
cover and place the cover in an
upside-down position. Remove
foam sleeve by sliding it up and
off the lid cage.
39. Shake the excess debris off of
the foam sleeve with a rapid up
and down movement.
40. Hold foam sleeve under
running water for a minute or
two, rinsing from the inside of
the sleeve. A water wash is not
always required, depending
on the condition of the foam
sleeve.
41. Check the filter for tears. If any
are found, replace with new.