Publicidad
Step 7
Fasten the END MOLDINGS (Q) to the ENDS (A). Tighten
å
four HIDDEN CAMS.
Fasten the BASES (K and L) to the ENDS (A) as shown.
å
Tighten four HIDDEN CAMS.
NOTE: The END (A) on the left will be called the LEFT
å
END and the END (A) on the right will be called the
RIGHT END.
The four small holes must
be closest to the top edge.
S u r
f a c
e w
i t h o
u t h
o l e
s
www.sauder.com/services
A
This END (A) will now be
called the LEFT END (A).
Q
Angled edge
Maximum
210 degrees
Minimum
190 degrees
S u r
f a c
A
This END (A) will now be
called the RIGHT END (A).
L
414958
Arrow
These holes must be
closest to the top edge.
e w
i t h
h o l
e s
Q
Angled edge
K
Page 11
Publicidad
