Publicidad
Idiomas disponibles
Idiomas disponibles
F_SETTING THE GROOWY UP FOR REAR FA-
CING INSTALLATION
USE FOR CHILDREN FROM 40 TO 105 CM
• To save space, in its original packaging the GROOWY seat is set up for
forward facing installation. The seat needs to be rotated 180 degrees on
its base before installing it in the vehicle.
• On the bottom of the base there is a red lever that releases the rotation
mechanism of the seat. Press it and turn the seat to the next locking posi-
tion.
1
.b
• Unfold the leg fully.
G_INSTALLATION OF THE SAFETY SEAT IN
THE CAR
• The ISOFIX anchors (6) are automatically extracted by firmly pulling both
the red rings (9) found on the front of the base.
• In some vehicles, the ISOFIX anchors are difficult to access or they are
hidden between the foam sections of the vehicle seat. With the seat we
have provided some guides (19) making it easier to locate them, insert
them before the following step.
• Guide the anchors towards the axles in your vehicle and press until both
sides are locked into place. Two green signals on the front of the base (8)
will show that they are securely anchored. If one or both of the signals are
red, try again.
1
.d
• Press the base (1) against the backrest of the vehicle.
• Release the lock for the leg by sliding the button (9a) to the right. Extend
28
EN
1
.a
1
.c
the leg until it touches the floor of the vehicle. Lift the seat until the button
(9a) locks again and the green signal is shown in the window of the button
(9a) and on the base of the leg (9b).
• When using the NEST baby carrier in the vehicle it must always be atta-
ched to the GROOWY safety seat in the rear facing position using the
exclusive JANÉ-CONCORD Pro-fix anchors.
H_FASTENING THE CHILD IN THE SEAT
WITH THE NEST BABY CARRIER (FROM 40 TO 65 CM)
• Loosen the integral seat belts by pulling the straps (23) above the buckle while
pressing the strap tightening button (23b).
2
• Unfasten the buckle (23a).
• Place the baby in the baby carrier making sure that he is sitting as far back
as possible. Bring the upper ends of the buckle together.
• Insert them into the fastener and press until you hear them click locked.
2
.d
• Pull the tightening strap (23b). The correct strap tension is very important for
the child's safety, do not leave the straps too loose.
• Position the baby carrier on the safety seat lining up the Pro-fix anchors
(24) with the slots in the armrests of the seat (16).
• Press both sides of the handle to make sure that the anchors have locked
into place. The two Pro-fix indicators (27) should be green.
• There is a cushion insert (15) for use with smaller children (from 60 to 75
cm).
• The seat has ventilation windows.
• The seat can be reclined.
1
.e
2
.a
.b
2
.c
2
.e
2
.f
2
.g
Publicidad
