Publicidad
Idiomas disponibles
Idiomas disponibles
EN
FR
DE
ES
IT
NL
1. Insert the large end of the hose into the blower
connection in the top of the motor housing. (Fig. 18)
2. Fit the crevice tool to the vacuum hose. (Fig. 19)
3. Ensure the power switch is turned off and plug in the
power supply.
4. Turn the motor on by fl ipping the switch to the "I" (ON)
position. (Fig. 14)
5. The unit will now blow through the vacuum hose and
can be used to clear obstructions within the hose.
6. Once you have fi nished operation, fl ip the switch to the
'O' (OFF) position and unplug the power cord from the
power outlet. (Fig. 15)
WARNING
If after a few seconds the hose continues to be blocked,
turn off the unit and clear the hose manually.
MAINTENANCE
INSTALLING AND CLEANING THE DRY FILTER
Note: Unplug machine from the power outlet before
performing maintenance.
Installing Dry Filter
1. Install the dry fi lter over the fi lter cage with the fl at end
of the fi lter towards the vacuum power head. Carefully
push fi lter in until it stops against the power head. (Fig.
20 & 21)
2. Place fi lter retainer on top of cartridge fi lter over
the raise lip and tighten down by turning retainer
clockwise, do not overtighten. (Fig. 22 & 23)
Removing And Cleaning Dry Filter (THIS FILTER IS
NOT WASHABLE)
1. Unlock and remove the fi ller retainer by turning
retainer handle anti clockwise.
2. Carefully hold and pull the dry fi lter up for removal.
(Fig. 24)
3. Clean the cartridge fi ller by gently tapping or brushing
dirt off. For optimal performance it is recommended to
regularly change this fi ller depending on level of use
(e.g., 3-6 months).
4. Install cleaned or new fi lter into place as instructed
above.
INSTALLING AND CLEANING THE FOAM FILTER
Note: Unplug machine from the power outlet before
performing maintenance.
Installing Foam Filter
Follow instructions to remove dry dust fi lter fi rst before
changing to foam fi ller.
Carefully slide foam fi lter down over the fi ller cage making
PT
DA
SV
FI
NO
RU
English
PL
CS
HU
RO
LV
LT
sure the whole cage is covered. (Fig. 9 & 25)
Cleaning Foam Filter
Carefully remove foam fi lter. (Fig. 26)
Use a mild soap and water solution to wash foam fi lter and
rinse with clean water. (Fig. 27)
Allow fi lter to air dry before installing and using again.
SYMBOLS
CAUTION! WARNING! DANGER!
V
Volts
Hz
Hertz
Alternating Current
W
Watts
Please read the instructions carefully
before starting the machine.
Recycle
Do not dispose of electric tools together
with household waste material.
Electric tools and electronic equipment
that have reached the end of their life must
be collected separately and returned to
an environmentally compatible recycling
facility. Check with your local authority or
retailer for recycling advice and collection
point.
European Conformity Mark
13
ET
HR
SL
SK
BG
UK
TR
EL
Publicidad
