Klarstein 10028189 Manual De Instrucciones página 19

Clean the filter screen
If the filter screen is clogged with dust, and the effectiveness of the air conditioning is reduced, be
sure to clean the filter screen once every two weeks.
Clean the upper filter screen frame
1 Clasp the wedging block of the EVA filter screen frame with
hands. Force down from the outside to remove the EVA
filter screen frame. Unscrew four screws fixing the EVA
filter screen and the rear housing to remove the EVA filter
screen (as shown in the above figure) .
detergent (about 40 ℃ / 104 ℉) and dry it in the shade
2 Put the EVA filter screen into warm water with neutral
after rinsing clean.
Clean the lower filter screen frame
1 Hold the handle of the CON filter screen frame, and pull it
outward gently to remove it.
detergent (about 40 ℃ / 104 ℉) and dry it in the shade
2 Put the CON filter screen into warm water with neutral
after rinsing clean.
Postseason Storage:
Unscrew the drainage cover, unplug the water plug, and discharge the water in the water pan into
other water containers or directly tilt the body to discharge the water into other containers.
Turn on the machine, adjust it to low-wind ventilation mode, and maintain this state until the
drainage pipe becomes dry, so as to keep the inside of the body in a dry state and prevent it from
mildewing.
Turn off the machine, unplug the power plug, and wrap the power cord around the wrapping post;
install the water plug and the drainage cover.
Remove the exhaust pipe and keep it properly.
Cover the air conditioning with a plastic bag. Put the air conditioning in a dry place, keep it out of
the reach of children, and take dust control measures.
Remove batteries of the remote control and keep them properly.
Note: ensure that the body is placed in a dry place and keep all machine components properly.
19
All manuals and user guides at all-guides.com
1
1 Retaining screw
2 Wedging block
3 Wedging block
2
3